1Ge xPON ONU was designed as the most cost-effective for FTTx networks and broadcasting networks, 1Ge LAN with xPON(for both GPON and EPON networks), 2 antennas for Wifi, 1 SC/APC, or 1 SC/UPC port for the bridge of FTTH to UTP networks, 1 power supply ports and 1 on/off switch for easy management. it saved many cost on components and chip’s requirement, the end-users can free extend to other LAN devices, such as high-performance routers, Mesh router, and switches, etc.
l 1GE+WIFI is designed as HGU (Home Gateway Unit) in deferent FTTH solutions; the carrier-class FTTH application provides data service access.
l 1GE+WIFI is based on mature and stable, cost-effective XPON technology. It can switch automatically with EPON and GPON mode when it access to the EPON OLT or GPON OLT.
l 1GE+WIFI adopts high reliability, easy management, configuration flexibility and good quality of service (QoS) guarantees to meet the technical performance of the module of China Telecom EPON CTC3.0.
l 1GE+WIFI is compliant with IEEE802.11n STD, adopts with 2×2 MIMO, the highest rate up to 300Mbps.
l XPON 1GE+WIFI are fully compliant with technical regulations such as ITU-T G.984.x and IEEE802.3ah.
l XPON 1GE+WIFI is designed by Realtek chipset 9602C
l Supports Dual Mode (can access GPON/EPON OLT).
l Supports SFU and HGU of EPON CTC 3.0 standard
l Supports GPON G.984/G.988 standards
l Support 802.11n WIFI (2×2 MIMO) function
l Support NAT, Firewall function.
l Support Flow & Storm Control , Loop Detection, Port Forwarding and Loop-Detect
l Support port mode of VLAN configuration
l Support LAN IP and DHCP Server configuration
l Support TR069 Remote Configuration and WEB Management
l Support Route PPPoE/IPoE/DHCP/Static IP and Bridge mixed mode
l Support IPv4/IPv6 dual stack
l Support IGMP transparent/snooping/proxy
l In compliant with IEEE802.3ah standard
l Compatible with popular OLT (HW, ZTE, FiberHome…)
1×10/100/1000Mbps auto adaptive Ethernet interfaces. Full/Half, RJ45connector
Compliant with IEEE802.11b/g/nOperating frequency: 2.400-2.4835GHz support MIMO, rate up to 300Mbps 2T2R,2 external antenna 5dBiSupport: Multiple SSID Channel:13Modulation type: DSSS、CCK and OFDMEncoding scheme: BPSK、QPSK、16QAM and 64QAM
7 LED, For Status of POWER, LOS, PON, LAN1~LAN2, WIFI, WPS
4, for Function of Power on/off, Reset, WPS, WIFI
Temperature : 0℃～+55℃Humidity :10%～90%（non-condensing）
Temperature : -40℃～+60℃Humidity :10%～90%（non-condensing）
Panel lights and Introduction
The WIFI interface is up.
The WIFI interface is sending or/and receiving data (ACT).
The WIFI interface is down.
The WIFI interface is securely establishing a connection.
The WIFI interface does not establish a secure connection.
The device is powered up.
The device is powered down.
The device doses not receive optical signals or with low signals.
The device has received optical signal.
The device has registered to the PON system.
The device is registering the PON system.
The device registration is incorrect.
Port is connected properly (LINK).
Port is sending or/and receiving data (ACT).
Port connection exception or not connected.
l Typical Solution：FTTO(Office)、 FTTB(Building)、FTTH(Home)
l Typical Service：Broadband Internet access, IPTV etc.